Edward Moore

Search This Blog

Media Tray (1)

February 14, 2004

Get link
Facebook
X
Pinterest
Email
Other Apps

Plowed grooves in #39 and #42 for the bottom of the media tray

steps:

J2

task hours:

3.0

project hours:

58.0

entertainment center

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Adjustable Shelves and Back

To space the support holes for adjustable shelves consistently, I created a template from scrap wood. [insert template diagram here] After drilling the support holes, I fitted the back into the rabbets and attached it with 3d nails. steps: B6-7 task hours: 2.0 project hours: 31.25

Route a dovetail groove

Clamped straight-edge guides to shelf (near right) Plowed a dovetail groove using a 3/8" dovetail bit Finished groove shown in far right picture

Drawer

[task hours: 7, project hours: ?] [steps H.6, H.7, H.8] Completed the drawer box and installed it using 20" slides. The box was was only a hair smaller than the cabinet front frame opening, so I rabbeted the sides 1-3/4" x 1/4" to accomodate the drawer slide. It's still a snug fit, but the drawer opens and closes relatively smoothly.

Powered by Blogger